Date: 01-12-2018
What is Scratch-Start TIG Ignition?
Scratch start is a very basic and rudimentary process, usually found on low cost inverter welders that have been essentially designed for Stick (MMA) welding.
The TIG tungsten electrode is scratched on the job to initiate the arc, and must be quickly lifted off the job to try prevent it sticking, but not lifted too far toavoid extinguishing the arc. Not a very user-friendly process!
Whilst some machine suppliers advertise their scratch-start machines as TIG (or stick/TIG),at Weldclass we believe that scratch-start machines are not suitable for TIG use. AllWeldclass "TIG" welding machines have either lift-arc or HF ignition.
What is Lift-Arc TIG Ignition ?
With Lift-Arc Ignition feature, to start the arc the tungsten electode is touched on the job and lifted off. The start-up current is very low and therefore the tungsten barely sticks to the job and the sharpened point is not damaged. The tungsten is then easily lifted off the job. The machine senses that the contact is broken and begins supplying full welding current.
Lift-arc offers great operator appeal as it is user friendly and very controllable. It can, however, challenge manufacturers as the electronic processes must be carefully calibrated to achieve good results. If the start up current is not minimised it will cause the tungsten to stick excessively to the job.
In the case of Weldforcewelding machines by Weldclass, the amperages and processes have been carefully refined to ensure optimum operation of the lift-arc process.
Lift-Arc Vs Scratch-Start
It is important to be aware of the difference between the ‘Lift-Arc’ ignition system and the ‘Scratch-Start’ ignition system.
Often DC inverter welding machines will be advertised as having TIG capability when they are a ‘Scratch-Start’ machine only.
Be warned! Scratch-Start isnot a user friendly process: the tungsten must be very quickly touched on the job and can very easily stick (which means the tungsten electrode must be removed and re-sharpened each time this occurs).
In comparison ‘Lift-Arc’ is very user friendly and very controllable.
What is HF TIG Ignition ?
HF (high frequency ignition) allows the operator to position the tungsten electrode near the job, and simply press the torch trigger to start the arc.
HF is typically found on professionalTIG welding machineswith AC/DC function, such as the Weldclass 201T or 202T. On these machines, often the controls will allow the operator to chose between Lift-Arc or HF start.
Other TIG welding articles:
The TIG Welding Process - your questions answered
While all care has been taken, Weldclass accepts no responsibility for any inaccuracies, errors or omissions in this information or links and attachments. Any comments, suggestions & recommendations are of a general nature only and may not apply to certain applications. It is the sole responsibility of the user and/or operator to select the appropriate product for their intended purpose and to ensure that the product selected is capable of performing correctly and safely in the intended application. E.&O.E.
-
Date: 20-07-2022
RutgerThanks from Holland!
-
Date: 12-03-2022
Johnny HedgeThanks this was very good information will help me in buying a machine
-
Date: 14-01-2020
WeldclassThank you for your question Ayoub. One of the causes of tungsten inclusion in the weld pool is "electrode dipping" (the tungsten electrode contacting the weld pool). Yes HF start does help to prevent this, as with HF there is no need for electrode contact with the job/workpiece.
-
Date: 14-01-2020
ayoub abdallaHow HF start heping to avoid tungsten inclusion????
